FAQs Preguntas frecuentes acerca de nuestros productos y soluciones

Realizar consulta Realizar consulta

All FAQs (1871 total: showing 661-680)

Can an SC929 be used to connect a datalogger CS I/O terminal with a sensor that has an RS-232 output?
What size barrel connector is used on the 15988?
What is the difference between a PS24 and a BP24? Is a BP24 with a CH100 equivalent to a PS24?
If a site is located in a fairly arid location, yet the RH reading from the CS215-L is 100%, what might cause this erroneous reading?
If the CS215-L is displaying a -100 (actually a -99.999) for temperature and RH, what is wrong?
What maintenance is recommended for the CS215-L?
If the reported values for temperature and/or relative humidity from a CS215-L are not valid numbers, what should be done?
How can the CS300-L be mounted if the 18356 leveling base is not used?
On routine site visits, how can the calibration of the CS300-L be checked?
Is it possible to read the output from a CS300-L in a 4 to 20 mA form?
Can a CS300-L be calibrated to a smaller range to measure only PAR (photosynthetically active radiation)?
Can the CS300-L be installed with more than 50 m of 16-AWG cable?
How often does the T107 or the ET107 need to be calibrated?
Can a T107 report data to a weather site such as Weather Underground?
Does the ET107 have heating capability for snow accumulation and a snow screen?
How can the ET107 RH chip be replaced?
Can a leaf wetness sensor be added to an ET107?
Can communication be initiated with the ET107 using Modbus?
Is there an option to allow the collection of the ET107 measurements either via a connection to a laptop or the use of a USB CompactFlash memory unit?
What methods of communication are possible with the CR1000M included with the ET107?

Anterior Siguiente