FAQs Preguntas frecuentes acerca de nuestros productos y soluciones

Realizar consulta Realizar consulta

All FAQs (1871 total: showing 901-920)

To measure sensible heat flux using the eddy-covariance technique, which fine-wire thermocouple should be used?
How can the pulse output of a 03101-L be converted to a 4 to 20 mA output?
If a cup breaks off the 03101-L, can the cup be replaced, or is a new sensor needed?
What might cause a 03101-L to produce a signal that is not high enough to be registered by the magnetic pickup?
How is the 03101-L, with its offset fitting and strain relief, mounted to the conversion kit?
Can the 03101-L be installed in a position that is tilted to the horizontal?
Is a device, such as the COM320, necessary for initiating a call when the measured parameters fall out of a specified range?
Can dual communication modes be run on a single CR1000 using a COM320 and an NL120?
Can a CWS900-series interface make thermocouple measurements?
How many CWS900-series interfaces can be put inside an enclosure, such as the ENC10/12, without causing interference issues?
Does the use of a CWS900-series interface require direct line-of-sight?
Does PC200W allow adding two different sensors to a multiplexer? If so, how?
How can control ports be configured so that they can be toggled using the port dialog in PC200W?
Does PC200W come with device configuration software, or is LoggerNet needed?
What is the difference between PC208W and PC200W?
Can LoggerNet and PC200W run at the same time on the same computer?
What do “serial port open failed” and “permission denied” error messages mean?
Does the “delete datalogger” function on the PC200W delete stored data on a data logger, a program, or both?
How can it be determined in PC200W which units of measurement are being used for a particular parameter?
Can PC200W be used to clear data from a data logger that does not have a keyboard?

Anterior Siguiente