FAQs Preguntas frecuentes acerca de nuestros productos y soluciones

Realizar consulta Realizar consulta

All FAQs (1871 total: showing 1741-1760)

I am looking for information on the 21X datalogger. Removal of the expansion memory module to be specific . I was trained on the CR10X in Edm, but have no info on the 21X.
Is the 03101-L capable of delivering a 0 to 5 Vdc square wave output for the wind speed?
Do heater resistance values of 37 to 48 ohm indicate a problem with the 229-L, or are those values within the normal range?
Is there a limit to how much memory the CR5000 can access/use through the PCMCIA interface?
Is it possible to transfer data from PC400 directly to a database such as Oracle (possibly through ODBC on Windows)?
What might cause the 014A-L to miss data, provide readings of 0 constant wind speed, and show various readings of gust speed?
How do you change the bearings of this sensor?
Is the CC640 a real-time camera?
I am trying to communicate with my new CC640 with a WinXP Pro SP2 notebook. I installed the CSI Device Config Utility (v1.3 from the included cd) and did the Power On - Setup on the camera, but I get "The Device version number, 1, is not defined for device, 11." I tried downloading the newest Device Config Utility (1.4) but it didn't have the CC640 listed. How do I communicate?
Would the SM4M replace an SM192 storage module or could I still get replacement battery for my SM192?
How many data lines can a SM192 and a SM4M store using a simple program?
1.Is there software that will allow the connection of SM4M to a laptop through a USB port since laptops do not often have a 9-pin com port?
1.Is there software that will allow the connection of SM4M to a laptop through a USB port since laptops do not often have a 9-pin com port?
If a version of PC208 will not recognize a SM4M, is there a download that can be used to retrieve the data?
I am looking for a net radiation and a solar radiation sensor for Idaho to be deployed during the summer and winter. Would the CNR1 be a good choice? I don't know if I will have enough power to use the heater consistently.
How often is recalibration recommended for the CNR1?
How high above the ground should a net radiometer be placed?
What kind of a regulator would you recommend if I want to set up a manually-powered generator to charge a 12-V gel battery? I have access to a 24 volt generator, but would that be too much do you think?
I have the CH12R (12V charger/regulator). I am trying to connect it to a 17.5-V, 290-mA, 5.1-W solar panel, to keep a 12-V battery charged. I just wanted to know how to go about doing this.
How many solar panels can be connected to a CH100 regulator? Can one 60 W solar panel and two 20 W solar panels be connected to the same regulator?

Anterior Siguiente