Toggle navigation
Productos
Soluciones
Soporte
Acerca de
Inicio
Productos
Soluciones
Soporte
Acerca de
Lista cotización
Contacto
Sitios web regionales
Sitios web regionales
Africa
Australia
Brasil
Canada
Centro Caribe
Deutschland
España
Europe
France
India
Japan
United States
ภาษาไทย
中国
Directorio paises
Log In
FAQs
Preguntas frecuentes acerca de nuestros productos y soluciones
Realizar consulta
Realizar consulta
Buscar
All FAQs
(1871 total: showing 1761-1780)
What might cause a PS100 or CH100 to fail after less than a year?
I have a PS100 with a charging regulator inside my enclosure. I would like to charge it with 110 V ac power at my site. I want to run my 110-V power cable directly into the enclosure, and not use a wall-mount style transformer/charger. Do you sell an ac transformer that will go inside my enclosure or should I buy one locally? Also, what is the preferred transformer voltage for the PS100?
What's new in SCWin 2.6?
Can an NL100 be set up through DevConfig using a 17394 cable instead of an RS-232 null modem cable? Would a 17394 connected to an SC32B be basically the same as an SC-USB?
What is the pin connection between USB and DB9 (RS-232) connectors?
Can a USB-to-9-Pin Pin (Male) RS-232 Cable (pn 17394) be used between a laptop and a CR10 datalogger, which has a storage module (SM192)?
I recently bought a laptop to replace an older laptop we used to communicate with four 21X Microloggers®. I discovered the new laptop did not have an RS-232 DB-9 port, but it does have two USB ports. I understand that the CS I/O port on the 21X is not standard RS-232 protocol. Will the 17394 cable work with the 21X or do you have another cable that will? Or do I need to do something else?
I'm looking for a wind monitor (speed and direction) that could be used with a tethered balloon system. The main feature I'm concerned with (aside from weight) is a built-in datalogger. Would you have anything that would meet this requirement or do all your systems require direct wiring to a separate datalogger.
Can the wind monitor be used without your datalogger?
If an existing wind set is replaced with a wind monitor (05103-L, 05103-45-L, 05106-L, 05305-L), will more than the multiplier and offset have to be changed in the datalogger program?
We have an R.M. Young marine anemometer with a cable that is about 13 ft long. We would like to extend the cable another 20 ft or so. Do you sell a separate extension cable for the anemometer?
What is the power consumption (mA) of the 05103, 05305, and 05106 anemometers?
What is the procedure for orienting my wind sensor to the cardinal directions so that the wind direction readings are correct?
How can the 229-L be calibrated?
How are readings obtained from the 229-L?
Is calibration of the 229-L available?
If several 229-L probes begin returning very low positive and negative values for dT, what might be the cause?
How should the AM25T be used?
Can the AM25T be connected to an analog input channel on a device other than a data logger, such as a programmable logic controller (PLC)?
How can the datalogger build a text string and send it out the RS-232 port?
Anterior
Siguiente