FAQs Preguntas frecuentes acerca de nuestros productos y soluciones

Realizar consulta Realizar consulta

All FAQs (1871 total: showing 1781-1800)

Instead of purchasing the entire 03001-L R. M. Young Wind Sentry Set, can I purchase just the Wind Sentry anemometer or Wind Sentry wind direction sensor to replace a bad unit from a previously purchased set?
I plan to set up an eddy covariance system in a remote wetland located in Michigan's upper peninsula. This site does not have power and is difficult to get to. I would like to set up a communication system that allows me to monitor the data from my office (Michigan Tech). There is a research station near the site (less than 5 km away--Seney National Wildlife Refuge) that could be used to collect the data before bouncing it to me.
I am writing from Universidad de Cuenca in Ecuador, and I would like to know if we can use ST-20 Argos Satellite Transmitter in Ecuador? Are there other choices for Ecuador?
Do Campbell systems support other satellite networks such as Iridium and Orbcomm? If the answer is "yes", do you know if the area of Somalia is covered by those services?
I need help with a satellite telemetry system to be used in northern Somalia for hydrological and meteorological station data transfer for a flood early-warning application.
What would be the best telemetry system for remote data collection from valley bottoms in a dense redwood forest?
Is the ST-21 Argos Satellite Transmitter compatible with the CR510 and CR10X?
I am looking for information on the 21X Micrologger, specifically about removal of the expansion memory module. I was trained on the CR10X, but have no info on the 21X.
Can a point-multipoint network be built using RF401 radios with a base and three remote terminals, a data logger at each terminal, a COM210 modem, and a remote PC with LoggerNet software?
How generic is the COM210 modem? I would like to remotely communicate with an entirely different scientific device (not a Campbell Scientific product). The normal way of interfacing with this product is via a direct RS-232C cable connection from the device to the serial COM port of a computer running application-specific Windows software.
What is the current shipping version of Baler?
Can NTUs be directly converted to SSC?
What turbidity standards should be used for calibrating OBS sensors?
Does it matter how sediment calibration standards are prepared?
Is fouling of OBS sensors something to be concerned about?
Do bubbles affect OBS data?
Does water color affect OBS measurements?
How big are the effects of sediment color on OBS measurements?
How does sediment size affect an OBS sensor?
How does sediment concentration affect an OBS sensor?

Anterior Siguiente